COMPONENTS
Resistor
Inductor
Thyristor
Gatepulse
AC Source
Ground
Ammeter
Voltmeter
OBSERVATION TABLE
| S.No. | VLrms (V) | VLavg (V) | ILavg (A) |
|---|
IL
17
18
VT1
5
6
9
7
8
T1
10
G1
VT3
11
12
T3
15
13
14
16
G3
FP1
19
20
21
GND1
37
38
R
VINP
1
2
3
4
AC
41
42
VLOAD
FP4
34
35
36
GND2
39
40
L
VT4
22
23
T4
26
24
25
G4
27
VT2
28
29
T2
32
30
31
G2
33
WAVEFORM
- STEP 1: Drag and drop the components in the workspace to create the circuit.
- Nos of required components:
- Thyristor – 4, AC Source – 1, Gatepulse – 4
- Resistor - 1, Inductor - 1, Ammeter – 1,
- Voltmeter – 8, Ground - 2
- STEP 2: Make the connections as per the instructions given below:
- (a) (1-3, 3-8, 2-4, 8-24, 14-30)
- (b) (4-30, 5-7, 6-8, 7-17, 13-17)
- (c) (18-37, 9-10, 11-13, 12-14, 15-16)
- (d) (10-19, 20-21, 22-24, 23-25, 26-27)
- (e) (27-35, 34-36, 28-30, 29-31, 32-33)
- (f) (25-31, 31-40, 38-39, 37-41, 40-42)
- STEP 3: Click on the CHECK button to check the connections.
- Note: Right click on the component to open the dialog box to edit the properties of the component.
- STEP 4: Input the values for all the required components (AC Source, Gatepulse, Resistor and Inductor) and the waveform will get plot automatically.
- STEP 5: Now, Click on the ADD button to insert the reading into the observation table.
- STEP 6: Now, you can input different values as per your requirement to get the desired waveform.
- STEP 7: Repeat Step 5 to again insert the reading into the table and now repeat Steps 6 to 7 to take more readings.
- STEP 8: Click on the PRINT button to take out the print of the webpage.
- STEP 9: Click on the RESET button to reload the webpage.